Most paver projects will vary depending on access, site conditions, project size and of course, the weather. These situations can have an overall impact on your project from a timing stand point. Careful consideration should be taken to determine the time to start the paver installation. Always try to minimize or avoid any traffic on the prepared areas.
Chairman or project manager should always be material (sand / Paving ) distributed around the project area can be a simple and effective institutions. Brick paver patterns should be placed in a manner not to interfere with the paver installation. The proper pallet/bundle placement can make the actual project installation easier and quicker by reducing the overall labor of handling the material.
Brick Paver Patterns
The coating can be placed in many different designs depending on their shape. Each paver form is usually a number of different hatch pattern .
Characterized in that the pattern and shape of the stent is very critical for the performance of the application. Entrepreneurs must take into account the weight of the traffic load of Brick paver patterns projects. 90 or 45 degree herringbone pattern is recommended for all street and driveway applications , as these models load support is required and takes creeping to turn the tires and start to brake or car traffic. In most applications in the world, it has been shown that machines completed successfully .
Pavers, which is 60 mm ( 3.2 / 8 ) has a thickness that is suitable for pedestrians applications. The coating , which will be used in commercial or industrial applications should be 80 mm ( 3 – to 1/8 inch) in thickness.
Reference / base for a brick paver installation
There are a number of factors , which determine the starting point for paver project.
When starting to install pavers it is best to snap a true straight chalk line on the surface of the bedding sand or pull a true straight string line above the surface of the bedding sand at the finished elevation of the Brick paver patterns. This will help as a guide for maintaining straight joint lines and will also allow the installer to make adjustments in the alignment of the pavers.
Buildings and concrete curb is generally not right and should not be used to create a direct connection lines. Use cord wires are required to determine the true installation well. installation progresses, the string lines help to minimize the need to cut small pieces.
The width of the joint between the vectors should be 1/16 and 3/16 (2 and 5 mm) . There are some pavers with spacer bars on their side. These maintain a minimum width of joint and let bedding and jointing sand between the popes to come. Coatings with a spacer are usually placed close to each other , because the rope will provide consistent joint spacing .